Eizo Color Edge CX240 Manuel d'utilisateur télécharger pdf (Page 33)

Chapter3SettingMonitor

3-7. Setting Signal Bandwidth

The range of frequency and detection sensitivity of the change in signal can be switched.

Attention

• The graphics board supporting signal display is required. Refer to the User’s Manual of the graphics board.

• This function cannot be used with HDMI input.

●

To connect DVI / DisplayPort

Procedure

1. Press

to turn off the monitor.

2. Holding

down, press for at least two seconds to turn on the monitor.

The “Optional Settings” menu appears.

3. Choose “Signal Bandwidth” from “Optional Settings”, and press .

4. Choose the input signal to set with

or , and press .

5. Select “Normal” or “Wide” with

or , and press .

6. Press

twice.

7. Select “Finish” with

or .

8. Press

3-8. Switching USB Port Automatically

This function allows the input signal to link the USB upstream port when one monitor is connected to two PCs.

This can switch the USB port automatically according to the switch of the input signal. To calibrate one monitor

using two PCs, the USB cables do not need to be connected again. USB devices such as the mouse and keyboard

connected to one monitor can be used with two PCs.

Attention

• To switch the USB port to be used, two USB cables are required. Prepare cables.

• If a storage device such as a USB memory is connected to the monitor, remove the device before changing the setting.

Otherwise, data may be lost or damaged.

• To connect one PC to one monitor, use USB upstream port 1. If these are not connected correctly, the USB function does not

work.

• The key arrangement of the keyboard cannot be changed.

Note

• When the “Input Selection” function is set to “Auto”, the USB port automatically switches according to the switch of the

input signal.

• The USB downstream port can be operated using the currently monitored PC.

Procedure

1. Choose “Tools” from the Adjustment menu, and press

2. Choose “USB Selection” from “Tools”, and press

3. Choose the input signal to set with

or , and press .

4. Select “USB-1” or “USB-2” with

or .

5. Press

to exit.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 70 71

Commentaires sur ces manuels

Pas de commentaire

Eizo Color Edge CX240 Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Affichages LED Eizo Color Edge CX240