Eizo FlexScan L665 Manuel d'utilisateur télécharger pdf (Page 25)

English

4. ADJUSTMENT

4-3. Color Adjustment

The <ColorManagement> menu in the ScreenManager enables to change the color of

the screen. By using the <Color Mode>, the adjustment mode can be selected from

<Custom mode> (to adjust the color settings according to your preference) and <sRGB>

mode.

In the analog input, perform the “Range Adjustment” (p.22) before making the

color adjustments.

NOTE

• Allow the LCD monitor to stabilize for at least 20 minutes before making image

adjustments. (Allow the monitor to warm up for at least 20 minutes before making

adjustments.)

• Performing the <Reset> of the <ColorManagement> menu returns the color settings

to the default settings (Except <Range Adjustment> settings).

• The values shown in percentages represent the current level within the specific

adjustment. They are available only as a reference tool. (To create an uniform white

or black screen, the percentages for each will probably not be the same.)

<Custom> mode: To adjust the color settings according

to your preference

To set the color temperature (p.36)

→ Set the <Temperature>.

The <Temperature> can be set from 4,000 K to 10,000 K, in 500 K increments

(including 9,300 K). Default setting is off (normal white).

NOTE

• The values shown in the Kelvin are available only as a reference tool.

• Setting the temperature under 4,000 K or over 10,000 K invalidates the color

temperature setting. (The color temperature’s setting turns “OFF”.)

To change the saturation

→ Use the <Saturation> adjustment.

The <Saturation> can be selected from –64 to 64. Setting the minimum level

(-64) turns the image to the monochrome.

NOTE

• The “Saturation” adjustment may cause undisplayable color tone.

To change the flesh color, etc.

→ Use the <Hue> adjustment

The <Hue> can be selected from - 16 to 16.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

Pas de commentaire

Eizo FlexScan L665 Manuel d'utilisateur Page 25