Eizo FlexScan S1932 Manuel d'utilisateur télécharger pdf (Page 5)

English

TroubleshootingSetting/AdjustmentPrior to use Installation

Installation/storage of the monitor with EZ-UP stand

If you have purchased the monitor with EZ-UP stand, please perform the following procedures when installing and

storing.

The stand of the monitor is fastened with a belt at the packing. Unfasten the belt after placing the monitor on the desk or

the stand may be unfolded suddenly. Keep the belt for future movement or transportation of the monitor.

Also, remove the cushion from the rear of the monitor at the installation.

Installing the monitor

Lift the monitor screen in the arrow direction.

Liftitbyholdingthepanelportionwithbothhands,untilyoumayhearthe“click”.Ifitclicks,themonitor

standlockissurelyfunctionedtousethemonitor.

Lower the monitor screen position, and unfasten the belt.

Hinge

StandBase

Cushion

Belt

Attention

•Unfasteningthebeltmaycausethestandtounfoldsuddenly.

•DonotusethemonitorwhentheEZ-UPstandisfolded.

•Afterreleasingthelock,takecarenottocatchyourngerswhenloweringthemonitor.Thismaycause

injuryordamagethemonitor.

Storage the monitor

Remove the cable holder.

Lower the monitor screen position until the hinge of the stand touches the stand

base, and fasten the stand with the belt.

Adjustthemonitoranglesoasthemonitorscreennottotouchthestandbase.

Fall the monitor screen backward with keeping slide-up the “Unlock” knob.

Whenmaximallytilting(25º)themonitorscreenbackward,the“Unlock”knobmaybehardtobeslid-up.

Then,slightlytiltupthemonitortoverticaldirectionandslide-upthe“Unlock”knob.

“Unlock”knob

1 2 3 4 5 6 7 8 9 10 ... 75 76

Pas de commentaire

Eizo FlexScan S1932 Manuel d'utilisateur Page 5