Eizo Color Edge CX240 Manuel d'utilisateur télécharger pdf (Page 43)

Chapter6Troubleshooting

6-4. Built-in correction sensor and SelfCorrection

problems

Problem Possible cause and remedy

1. The built-in correction sensor does not

come out/stays out.

• Turnoffthemainpower,andthenturnitonagainafew

minuteslater.

• Ifaproblemstillremainsafterapplyingthesuggested

remedies,contactyourlocalEIZOrepresentative.

2. SelfCorrection cannot be executed. • CheckwhethertheColorNavigatorlicenseiscertied.

(See“TouseColorNavigator”(page10).)

• SettheSelfCorrectiontargetusingColorNavigator.

3. SelfCorrection failure • Refertotheerrorcodetable.Ifanerrorcodethatdoes

notappearintheerrorcodetableisdisplayed,contact

yourlocalEIZOrepresentative.

Error Code Table

Error Code Description

0014 • ExecuteSelfCorrectionagain.

• AdjustusingColorNavigator.

0034 • Thebuilt-incorrectionsensormaynothavecomeoutduringcalibration,orlightmay

haveenteredthesensorduringmeasurement.

• Turnoffthemainpower,waitforafewminutesbeforeturningthepowerbackon,and

thenexecuteSelfCorrectionagain.

0050 • ExecuteSelfCorrectionagain.

0061 • Thebuilt-incorrectionsensormaynothavecomeout.

• Checkwhetherthereisanyforeignobjectnearthebuilt-incorrectionsensor.

• ExecuteSelfCorrectionagain.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 70 71

Pas de commentaire

Eizo Color Edge CX240 Manuel d'utilisateur Page 43